BD-SW-5BC-11 - Yamaha R1 2015 >2019 and 2020 - 5 function race switch - brake mount - Stop/Run Start Up/Down Set

Code BD-SW-5BC-11
Click the image to enlarge
Code BD-SW-5BC-11
£310.00 Exc VAT
Earn 0 reward points with this product.
  • Description

    Make : Yamaha

    Model : R1

    Year : 2015 onward

    Part Number : BD-SW-5BC-11 

    Number of switch functions : 5

    Position : Right side

    Road or Track : Both, use the pull down options to add brake switch wiring

    Mounting type : Mounts directly onto the brake master cylinder

    Download the switch assembly product : Datasheet


    This switch is intended to replace the standard right hand handlebar switch to provide simple Up, Down and Select push buttons replacing the scroll wheel via an intelligent control circuit board embedded within the switch body. No user programming is required, just plug it in and use it.

    • On/Off (kill switch)
    • UP function
    • Select (mode) function)
    • DOWN function
    • Starter

    Note : The 2020 bike features a 1 piece switch and twist grip sensor housing. To use this separate switch component you must either use our KT160 throttle housing or a similar aftermarket product.


    These 'Type C' switches mount directly onto the  brake master cylinder using the two original clamp screws and a new dedicated clamp. 

    We have brake clamps for:

    • BR-A    32mm in-line bolt spacing 
    • BR-B    30mm offset bolt spacing - Brembo XR , GP
    • BR-N    32mm in-line with a left offset for short brake levers Nissin / Brembo RC, RCS, Costa Corta
    • BR-F    30mm in-line as found on Accosato / Hel components
    • BR-J     32mm offset bolts spacing as found on Beringer components
    • BR-G    Generic clamp for any 21.8 > 22.2 mm handlebar (does not mount on the brake pump)

    Unless otherwise specified we will supply the BR-A clamp for this application.

    Specify clamp type at the time of ordering. One clamp is supplied free of charge per switch.

    Alternative clamps can be purchased separately, no need to replace the switch assembly.


    Construction / Notes:

    • Billet aluminium body
    • IP 67 waterproof switches with gold plated contacts
    • Raychem type 55 wire and DR25 sleeving
    • Plug and play wiring 
    • Greater crash protection and electrical integrity
    • May be repaired after crash damage
    • Custom designs are our speciality, so feel free to ask and typically at no extra cost.
    • Designed and manufactured in the UK at our workshops close to Silverstone
    • If you are not sure, call us for advice on 0044 (0)1327 263942 - UK
    • See below for compatible products